Performing a partial or total shedding of the boiler ?
Connect the output(s) of the shedder to the shedder terminals numbered 11 to 13 on the boiler (see technical manual).
- The output(s) of the shedder must be dry contacts.
OR:
Use parameter 23 to choose the shedding level
- In the parameter settings menu, set parameter 23 to the value:
- 03: 1st triac shedding
- 04: 1st + 2nd triac shedding
- 05: 1st + 2nd + 3rd triac shedding
These questions might also interest you
How to adjust the speed of the circulator?Can the power of Gialix be reduced ?What needs to be done to install the domestic hot water production ?Use off-peak / peak hours signal.How to control the boiler with an external controller ?How to connect and declare a room thermostat ?Connect and declare an outdoor sensor in AUTO modeHow to access the installer settings ?Information and heating setpoint calculated by boilerHow to program time slots ?What thermostat can I connect ?
